Your cart is empty

Alumilite QuickSet Silicone Rubber

Starting at: $38.99

Alumilite's QuickSet silicone mold making rubber is one of our most easy to use silicones. It is great for making simple one and two piece molds that does not require extreme stress or flexibility. Its low viscosity gives you excellent detail reproductions of your original without requiring vacuum degassing (always recommended if available). The QuickSet is a tin base silicone. Temperature and humidity may affect the work and cure speed of the rubber. The QuickSet cures against all different types of clays including sulfur based with any problems of inhibition. The QuickSet is a great general purpose rubber for making 2 piece molds that need good alignment to one another. QuickSet exhibits good overall dielectric properties for electronic applications.

Product QuickSet
Color Tan
Mix Ratio (wt. or Vol.) 10:1 by wt.
Open Time 30 Minutes
Demold Time (100 gr. Mass) 8-18 Hours
Mixed Viscosity (cps.) 13,000
Specific Gravity 1.15
Shore A Hardness 40-50 A
Linear Shrink % .0025
Tensile Strength (psi) 400
Tear Strength (ppi) 20
Elongation (in./in.) 180%
Temperature Resistance (F) -67 to 395
Vacuum Required No

Please Choose:


Product Model :
Product Model :
Product Model :
Add to Cart:

This product was added to our catalog on Tuesday 23 October, 2012.

Copyright © 2018 Plastic World. Powered by Zen Cart
Designed by
Your IP Address is:
waelectronics template